A burst pipe in winter rarely splits where the ice sits. Ice blocks the line, and water trapped between the blockage and a closed faucet builds pressure until the weakest point gives way. That is why many bursts are found days later, when the thaw comes and water starts running out of a ceiling or wall.
First steps
- Close the main shutoff valve, usually where the water line enters the house or beside the meter
- Turn off the water heater if the hot side is affected
- Open the lowest faucet in the house to drain the lines
- Switch off power to any area where water is reaching outlets or fixtures
- Take photos for your insurance claim before cleanup starts
How the repair is made
The plumber opens enough wall or ceiling to reach the damaged section, cuts out the split, and joins new pipe with soldered, press or push-fit fittings depending on the material. Copper usually splits along its length. PEX can stretch somewhat before failing, but fittings can still crack. Older galvanized steel may be corroded enough nearby that a longer section should be replaced.
After the repair, the system is pressurized and checked for other weak spots along the same run. If the pipe froze once, it will likely freeze again in the same spot, so ask about insulation, heat cable or rerouting while the wall is open.
Brightpipe Plumbing books burst pipe repairs with plumbers in Ruby, SC and nearby towns.